Xerox 6100 User Manual page 83

Always close the printer covers gently. Never expose the printer to vibrations.
Do not cover the printer immediately after using it. Turn it off and wait until it cools
down.
Do not leave the printer open for any length of time, especially in well-lit places;
light may damage the OPC belt cartridge.
Do not open the printer during printing and do not tap paper stacks on the printer.
Do not tilt, lubricate, or disassemble the printer.
Do not touch the electrical contacts, gears, or laser beam devices. Doing so may
damage the printer and cause the print quality to deteriorate.
Keep media in the output tray at minimum level. If the media stacks too high, your
printer may experience media jams and excessive media curl.
Lift the printer from the bottom only, using the carrying grips under each side cor-
ner. Make sure at least two people are available to lift the printer when moving it.
When moving the printer, keep the printer level to avoid spillage of fuser oil. See
chapter 7, "Repacking the Printer," for printer shipping instructions.
Keep the following in mind when storing the printer for an extended period:
—Unplug the printer.
—Leave the OPC Belt Cartridge installed in the printer to help eliminate toner
contamination.
—Remove the toner cartridges from inside the printer. After removing the car-
tridges, return them to their original packaging. If the original packaging is not
available, protect the toner cartridges from spilling toner.
—Follow the procedures described in "Prepare the Fuser Unit" in chapter 7,
"Repacking the Printer."
—See appendix B, "Technical Specifications," for storage specifications. See
chapter 7, "Repacking the Printer," for printer shipping instructions.
Everyday Operations and Printer Care
Handling the Printer
3-29