Opc Belt Cartridge Problems; Control Panel Problems; Paper Jam Message Stays On; Printer Resets - Xerox 6100 User Manual

OPC Belt Cartridge
Problems
3 Is the printer receiving data from the computer?
If the Data indicator blinks after a file is sent, the printer is receiving the data. If
not, check the following:

OPC Belt Cartridge Problems

The OPC belt is extremely sensitive to bright light and direct sunlight. Always leave it
in its protective bag until you are ready to install it. Any exposure to light should be lim-
ited to two minutes. If you suspect the belt is damaged due to exposure to light, put
the belt in a dark place to recover. Depending on the amount of exposure, recovery
may take up to two hours. Recovery time is dependent on the amount of exposure
sustained, and recovery is not guaranteed.

Control Panel Problems

Paper Jam Message Stays On

If a media jam message stays on, open the printer and clear the jam.
If the message is still there, try opening and closing the top of the printer again. See
the preceding section on clearing media jams for more information.

Printer Resets

Occasionally, software applications interfere with each other. Some applications send
a printer prep file to the printer at the beginning of each document. When this occurs,
other prep files cannot be sent without resetting the printer. Monitor your activities to
6-24
Is the printer on line? The online indicator should be on and the message
window should display IDLE.
Is the printer interface cable securely attached to the printer connector?
Turn off the printer, remove the interface cable, then reattach the cable
securely to the printer interface connector.
If you still cannot identify the problem, contact your local vendor.
magicolor 6100 DeskLaser User's Guide