Installation Troubleshooting; Status And Service Messages - Xerox 6100 User Manual

Installation
Troubleshooting

Installation Troubleshooting

If you see this...
Colors aren't registering
properly.
CHECK WASTE TONER
message appears in the
message window.
Printouts seem faded on
one side of the page.
The colors look
drastically wrong.
The startup page comes
out skewed.
If you've followed all of the instructions in this chapter and still have problems you
can't solve, see the Service & Support Guide for information on getting help.

Status and Service Messages

Status and service messages are displayed in the control panel message window.
They provide information about your printer and help you locate many problems. See
"Clear Care," under the "Configuration Menu" heading of chapter 1 for information
about clearing service messages from the message window.
6-14
It's probably because...
The OPC belt cartridge is
not pushed all the way in.
The waste toner pack isn't
properly installed.
The printer is not on a level
enough surface.
The toner cartridges are
not correctly installed.
The transfer unit was
jarred open during the
installation and needs to
be closed.
magicolor 6100 DeskLaser User's Guide
Do this...
Repeat the steps in "Installing the OPC
Belt Cartridge" of the Installation Guide .
Make sure it sits loosely in its
compartment and that the top of the pack
is not wedged under the top of the
compartment.
Level the printer surface. The slant of the
surface holding the printer should not
exceed 1.5° after the printer is placed on
it (for example, a round pencil laid on the
surface shouldn't roll in any direction).
Check the toner cartridge installation.
Refer to "Installing the Toner Cartridges"
of the Installation Guide .
Refer to the steps in "Cleaning the
Transfer Unit" on page 6-30 for
information on opening and closing the
transfer unit.