Fig.9 Manner Of Assembling/Pulling Out Of The Blow-In And Suction; Fig.10 Condenser Cleaning - Igloo JAMAJKA W Series User Manual

Table of Contents

Advertisement

Available languages

Available languages

1
Fig.9 Manner of assembling/pulling out the blow-in and suction
1 – Inner top
2 – Blow-in (DO NOT BLOCK the holes!!!)
3 – Suction (DO NOT BLOCK the holes!!!)
Do not use mechanical agents in order to fasten the defrosting process!
It is recommended to make a break in the exploitation of the device once a month in order to clean its interior, naturally
defrost the evaporator, clean the condenser and evaluate the condition of door seal (Jamajka 0.6).
Condenser of the device should be kept clean. Impurities obstruct
the heat exchange and may cause, among others, increase in elec-
tric energy consumption and might lead to aggregate compressor
damage.
In order to cleanse the condenser it is necessary to unscrew fi xing
plate screws and remove the wind brace. Clean condenser lamellas
with soft tuft or brush. In case of signifi cant contamination of the con-
denser (lamellas being clogged) it is recommended to use vacuum
cleaner or compressed nitrogen to suck off/ blow out the dirt found
between the lamellas.
The producer shall not be liable for damages of the condensing aggregate resulting from non-
observance of condenser purity!
(This concerns Jamajka 0.6) Door seal should be cleaned solely with clean water without any cleansing
agents and it should be thoroughly dried. The seal cannot get into contact with oily substances or
grease! Control whether door close properly during maintenance procedures.
Test: place a sheet of paper between the seal and the casing and close the door. The paper should
pose a tangible resistance during an attempt to pull it out.
Elements of device can corrode when improper used and maintenance. To avoid that please
follow the rules:
• Do not allow contact of the surface of the device with substances containing chlorine and / or baking
soda in different varieties, which destroy the protective layer and components of the device (also
includes various stainless steel)
18
User manual Jamajka W, Marta W
2
3

Fig.10 Condenser cleaning

en
www.igloo.pl

Advertisement

Table of Contents
loading

Table of Contents