Fig.3 Fixing The Hook In The Frame; Fig.4 Hook Height Regulation; Fig.5 Assembly Of Glass Elements - Igloo JAMAJKA W Series User Manual

• Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by means of
extension cords or dividers!)
• Switch on the main switch Fig.6/1 (p.16), which activates the thermostat, and then aggregate of the device
• Set the temperature on thermostat control panel Fig.6/3 (p.16) (service details on p. 21 or 22)
• Switch on the lighting switch Fig.6/2 (p.16)
• In case of display cabinets equipped with hygrostat (it does not concern Carel thermostat) it is possible to set the
desired humidity inside the device by means of knob Fig.7 (p.17). Within the range of temperature between 10ºC and
15ºC it is possible to control air humidity between 30 and 80%.
2 – Protective pipe covering lamp cord
3 – PVC profi le hiding the vertical frame post
When changing the height of the hook it is necessary to sligh-
tly tilt the PVC profi le and pull the protective pipe into proper
position. Then the hook should be pulled out of the frame and
place it in proper position and under proper angle.
1
6
www.igloo.pl
1 2 3

Fig.3 Fixing the hook in the frame

1 – Vertical post of the internal frame
2 – Hook mounting holes

Fig.4 Hook height regulation

2
3 – Hook (adjusted to three-stage regulation
of mounting angle)
1 – Hook
3

Fig.5 Assembly of glass elements

1 – Glass side
4 3
2 – Glass shelf
5
3 – Lifted front glass
4 – Upper aluminium profi le (lifted guide)
5 – Lower aluminium profi le (hinge) of the
6 – Inner top
User manual Jamajka W, Marta W
of the glass
glass
en
1
2
3
15