Mitsubishi Electric PWFY-P100VM-E-BU Data Book page 69

• Fix power source external input/output line wiring to control box by using buffer bushing for tensile force to prevent
electric shock. (PG connection or the like.) Connect transmission wiring to transmission terminal block through the
knockout hole of control box using ordinary bushing.
• After wiring is complete, make sure again that there is no slack on the connections, and attach the cover onto the
control box in the reverse order removal.
[Fig. V. 1.(5).2]
•PWFY unit
(A)
(A)
(B)
(C)
(A)
(D)
(E)
(G)
(F)
•Solenoid valve kit
(B)
(D)
(E)
Caution:
Wire the power supply so that no tension is imparted. Otherwise disconnection, heating or fire result.
(A) To prevent external tensile force from applying to the wiring
connection section of power source terminal block use buffer
bushing like PG connection or the like.
(B) External signal input cable
(C) External signal output cable
(D) Power source wiring
(E) Tensile force
(F) Use ordinary bushing
(G) Transmission cable and MA remote controller cable
(A)
(A) To prevent external tensile force from applying to the wiring
(A)
connection section of power source terminal block use buffer
(C)
bushing like PG connection or the like.
(B) External signal input cable
(C) Power source wiring
(D) Tensile force
(E) Back view
- 61 -