Table of Contents
Advertisement
5.2 Removal
• When the module fixing screw is used, always remove the module by removing the module
fixing screw and then taking the module fixing projection off the module fixing hole of the
base unit.
Attempting to remove the module by force may damage the module fixing projection.
• Do not touch the heat radiating fins of controller or module case, etc. while the power is ON
and for a short time after the power is turned OFF. In this timing, these parts become very
hot and may lead to burns.
Remove the modules while paying attention.
• Completely turn off the externally supplied power used in the system before installation or
removing the module. Not doing so could result in electric shock or damage to the product.
Push
Module fixing hook
Base unit
Module
connector
Module fixing hole
Liftting
Pul l
17
Module
Advertisement
Table of Contents
