Before Use - aidapt Medina VR127 Fixing And Maintenance Instructions

Table of Contents

Advertisement

Available languages

Available languages

INTRODUCTION
Thank you for deciding to purchase the Medina Bath Seat/Board from Aidapt. The Medina Bath
Seat/Board range is manufactured from the finest materials and components available, when used
correctly it is designed to give many years of reliable trouble-free service.
Please Note: Always consult with the prescriber/Physiotherapist if you are in any doubt that this
product is suitable for your use.
NB. This equipment must be installed by a competent person, and a risk assessment may be
needed as to the suitability of the equipment for the particular user
VR127/VR128/VR129
VR127A/VR128A/VR129A
VR116/VR117/VR118
VR116A/VR117A/VR118A
VR124/VR125/VR126
VR124A/VR125A/VR126A
Do not exceed the weight limit stated – doing so could put the user at risk.

BEFORE USE

Carefully remove all packaging. Avoid using any knives of other sharp instruments as this may
damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault, do not use
your product, but contact your supplier for support.
FITTING BATH AND SHOWER BOARDS
1.
Turn the board over with the cleats facing upwards (see fig. 1)
2.
Loosen off the wing nuts holding the wing nuts holding the cleats in position (see fig. 2)
3.
Turn the board over so that the slats are facing upwards.
4.
Place the board over the bath traversing its width.
5.
Reach underneath the board and push both cleats outwards evenly until
they are gripping the wall of the bath.
6.
Tighten off the wing nuts. N.B. It is only necessary to tighten the wing nuts
finger tight. Do not over tighten them as this can cause the threaded brass
insert to come lose, which could cause the product to fail.
7.
Double check the cleats are friction tight to the wall of the bath before use.
Always check the tightness of the board before each use
Always repeat the installation every time the board is removed
Always make sure the correct width of board is installed to suit the bath onto
which it is to be fitted.
Fixing and Maintenance Instructions
Medina Bath Seat
Medina Bath Seat
Medina Bath Board
Medina Bath Board
Medina Shower Board
Medina Shower Board
2
30 st (190 kg) weight limit
30 st (190 kg) weight limit
25 st (159 kg) weight limit
25 st (159 kg) weight limit
25 st (159 kg) weight limit
25 st (159 kg) weight limit
Ver.6 08/2012 (1545)

Advertisement

Table of Contents
loading

Table of Contents