Special Setups For Copying; Resolution Setup; Zoom Setup - Xerox Phaser 3100MFP/S User Manual

Phaser 3100MFP/S
3 Choose the paper tray AUTOMATIC or MANUAL
with the buttons
button.
Copying in ID Card mode is only
possible on A4 (original document
size < A5) or Letter (original
document size < Statement) paper
Important
size. Make sure that the selected
paper tray uses the correct paper
size.
4 Choose the copying option ID CARD with the
buttons or and confirm with the OK button.
5 Choose the resolution depending on the desired
printing quality AUTO, TEXT, PHOTO or QUALITY
TEXT with the buttons
the OK button. For optimal results with ID
documents, select the PHOTO resolution.
6 Adjust the contrast level with the buttons
then confirm with the OK button.
7 Adjust the desired brightness level with the buttons
or , then confirm with the OK button.
8 Choose the paper type NORMAL, THICK with the
buttons or , then confirm with the OK button.
The LCD screen displays the following message:
PUT ID CARD
THEN OK
9 Place your identity card or any other official
document against the document glass, as shown
below:
10 Press the OK button.
The document is scanned then the LCD screen
displays the following message:
TURN UP DOC
THEN OK
11 Turn your document over then confirm with the
OK button.
The machine prints out a copy of your document.
or , then confirm with the OK
or , then confirm with

Special setups for copying

Setups done through this menu become the device
default setups after you confirm.
Important

Resolution setup

The RESOLUTION parameter allows you to setup the
photocopy resolution.
841 - ADVANCED FCT/COPY/RESOLUTION
1 Press , enter 841 using the keypad.
2 Choose the resolution with the buttons
or ,
according to the following table:
Parameter
AUTO Low resolution.
Standard resolution for
TEXT documents containing text and
graphics.
Optimal resolution for
PHOTO documents containing
photographies.
QUALITY Optimal resolution for
TEXT documents containing text.
3 Confirm your choice by pressing the OK button.
4 Exit this menu by pressing the
Note

Zoom setup

The ZOOM parameter allows you to reduce or enlarge an
area of a document by choosing the origin and the zoom
level to apply to the document, from 25 to 400 %.
842 - ADVANCED FCT/COPY/ZOOMING
1 Press , enter 842 using the keypad.
2 Enter the
alphanumerical
predefined values with the buttons
3 Confirm your choice by pressing the OK button.
4 Exit this menu by pressing the
- 22 -
When the quality of the printing is
not satisfying, you can perform a
calibration (see Calibrate your
scanner, page 26).
Description
button.
You can also change the resolution by
pressing the button.
desired zoom level
keypad or choose
button.
or
Icon
none
with the
among
and .