Setting The Slave Group; Testing Remote Flash Mode - Metz mecablitz 64 AF-1 digital Operating Instructions Manual

10.2.3 Setting the slave group

Gr Ch
REMOTE
• Press the sensor button on the touch
SLAVE
A 2
display for the channel group (e.g
M-
The window for selecting the channel and
Zoom 24 m
m
group appears.
O
SLAVE
• Press the sensor button on the touch
CHANNEL
display for the group
GROUP
• Press the
touch display to select the desired group
O
GROUP
"A", "B" or "C".
GROUP A
• Press the sensor button on the touch
GROUP B
display for the selected group, e.g.
GROUP C
k
.
p
q
Gr Ch
REMOTE
SLAVE
B 2
M-
Zoom 24 m
m
The setting will take effect immediately. "B"
appears on the display
170
Gr A I Ch2
).
GROUP
.
sensor buttons on the
GROUP B

10.3 Testing remote flash mode

• Place the slave flash units in the desired
positions for the shot. Use flash unit moun-
ting foot S60 (optional accessories) to set
up the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF auxiliary ligh
will blink.
• Take a test shot and check whether the sla-
ve flash unit(s) respond.
• If the slave flash unit does not flash, correct
the position of the slave flash unit so that it
can receive the light from the controller
flash unit or reduce the distance between
the controller flash unit and the slave flash
unit.
• Following the successful completion of the
flash test, you can start taking shots.