Advertisement
6. When you start at the next section of the concrete
surface, put 15 cm/5.9 in. (A) of the beam on the
smooth concrete surface to make an overlap.
To adjust the work angle on the handle
1. Move the beam forward on the concrete surface. At
the same time turn the handle clockwise until the
front edge of the beam is slightly lifted.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Daily maintenance
•
Make sure that all the nuts and screws are tight.
•
Clean the product.
•
Lubricate the swivel.
To clean the product
•
Remove concrete from the surfaces of the product
after each operation before the concrete becomes
hard.
Storage
•
Clean the product before storage.
1160 - 001 - 09.04.2020
2. Put the handle on your shoulder.
3. Pull the beam rearward. At the same time turn the
A
Maintenance
•
•
•
To lubricate the swivel
•
Storage and disposal
•
•
handle counterclockwise until the rear edge of the
beam is slightly lifted.
Use water and a brush to clean the product.
Spray the beam with concrete form oil or concrete
release agent. This makes it easier to clean the
product after the next operation.
Remove grease and oil from the handle.
CAUTION: Do not use different types of
grease. Refer to
for correct type pf grease.
Lubricate the swivel between the handle and the
beam after each time that the product is cleaned.
Keep the product in a dry and frost-free area.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Technical data on page 6
5
Advertisement
