Advertisement
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product.
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Use personal protective equipment. Refer to
Personal protective equipment on page 3 .
•
Clean the product to remove dangerous material
before you do the maintenance.
To assemble and disassemble the
handle
1. Assemble the handle (A). Make sure that the locking
pins (B) engage in the holes in the handle tube.
A
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
•
Read the operator's manual carefully and make sure
that you understand the instructions.
•
Examine that the product is in good condition. If it is
necessary, replace damaged parts.
•
Clean the product.
To operate the product
1. Spray the beam with concrete form oil or concrete
release agent. This makes it easier to clean the
product after operation because the concrete does
not attach to the beam.
2. Put the beam at the start of the first section of the
concrete surface.
4
Assembly
B
B
Operation
•
Do not change the product. Modifications that are
not approved by the manufacturer can cause serious
injury or death.
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
Replace damaged, worn or broken parts.
•
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
•
Let an approved service agent do servicing on the
product regularly.
2. Disassemble the product in the opposite sequence.
3. Turn the handle to adjust the operation angle of the
beam against the concrete surface. Refer to
adjust the work angle on the handle on page 5 .
4. Put the handle on your shoulder.
5. Walk slowly rearward and pull the beam to smooth
the surface. The beam removes your shoe prints
from the concrete surface.
To
1160 - 001 - 09.04.2020
Advertisement
