C3850-Nm-2-10G Module; C3850-Nm-8-10G Module - Cisco Catalyst 3850 Hardware Installation Manual

C3850-NM-2-10G Module

Interface
GigabitEthernet1/1/3
GigabitEthernet1/1/4
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
C3850-NM-2-10G Module
In the C3850-NM-2-10G module, the first two parts are natively 1-G ports and the last two ports are natively
10-G ports. So, you configure the 1-G posts as GigabitEthernet1/1/1 through GigabitEthernet1/1/2, and
configure the last two ports as TenGigabitEthernet1/1/3 through TenGigabitEthernet1/1/4, even when you
are operating the last two ports as 1-G. Only four interfaces are valid, and the other four should not be used
even though they still show up in the CLI.
Table 22: C3850-NM-2-10G Module
Interface
GigabitEthernet1/1/1
GigabitEthernet1/1/2
GigabitEthernet1/1/3
GigabitEthernet1/1/4
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4

C3850-NM-8-10G Module

All ports in the C3850-NM-8-10G module default to 10 G and should be configured as TenGigabitEthernet1/1/1
through TenGigabitEthernet1/1/8, even when you are operating them as 1 G using SFP.
Table 23: C3850-NM-8-10G Module
Interface
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
Catalyst 3850 Switch Hardware Installation Guide
62
Action
Disregard
Disregard
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Action
Configure this interface
Configure this interface
Disregard
Disregard
Disregard
Disregard
Configure this interface, even when operating as 1-G
Configure this interface, even when operating as 1-G
Action
Configure this interface
Configure this interface
Installing a Network Module
OL-26779-05