Connecting The Rj-45 Console Port; Connecting The Usb Console Port - Cisco Catalyst 3850 Hardware Installation Manual

Connecting the RJ-45 Console Port

Note If you have stacked your switches, connect to the console port of one of the switches in the stack. You can
initially configure the entire stack from any member switch.
Connecting the RJ-45 Console Port
Procedure
Step 1 Connect the RJ-45-to-DB-9 adapter cable to the 9-pin serial port on the PC. Connect the other end of the cable
to the switch console port.
Step 2
Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC application
such as HyperTerminal or ProcommPlus, makes communication between the switch and your PC or terminal
possible.
Step 3 Configure the baud rate and character format of the PC or terminal to match the console port default
characteristics:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• None (flow control)
Step 4
Power on the switch as described in the switch getting started guide.
Step 5 The PC or terminal displays the bootloader sequence. Press Enter to display the setup prompt.

Connecting the USB Console Port

Procedure
Step 1 If you are connecting the switch USB console port to a Windows-based PC for the first time, install the USB
driver. See
Note
Catalyst 3850 Switch Hardware Installation Guide
108
Installing the Cisco Microsoft Windows USB Device Driver, on page
USB Type A port on the switch provides file system support and is NOT a console port. See USB
Type A Port section.
Configuring the Switch
111.
OL-26779-05