Table of Contents
Advertisement
Install the Luminaire
Instructions for installing 100–277 V standard luminaires are below. See
Emergency Multi-Cell Luminaires on page 38
luminaires.
Two-cell
luminaire
B
C
Four-cell
square luminaire
B
C
Note:
luminaire, conduit hardware, and all cable required for installation.
1.
Make sure power is off at the main circuit breaker.
2.
Attach a C-clamp or other mounting hardware (not provided) to the yoke of the luminaire.
3.
Attach the luminaire to a pipe or other approved mounting device.
4.
Insert or attach additional accessories, if desired.
5.
Using a Phillips head screw driver, remove the screws securing the cover to the luminaire's
wiring compartment. Set the screws aside for later re-installation. The cover is grounded
to the enclosure by a tether.
6.
Install conduit hardware at the conduit entry in the side of the wiring compartment.
Standard System Multi-Cell Installation
A
A
A wiring compartment
B conduit entry for 1/2 in conduit
C DMX in and thru
Mounting hardware and installation location must support the weight of the
for instructions on installing 100–277 V emergency
Four-cell
linear luminaire
C
B
Eight-cell
luminaire
C
B
Installing 100–277 V
A
A
33
Advertisement
Table of Contents
