Download Print this page

ETC Irideon AR500 Troubleshooting Manual

Exterior wash luminaire
Hide thumbs Also See for Irideon AR500:

Advertisement

Quick Links

Fixture does not retain focus.
Fixture does not retain focus.
Fixture does not retain focus.
Fixture does not retain focus.
Torque bolts to 20ft/lbs.
On the Remote Version, remove excess silicone from remote mount top and bottom, replace O-ring.
You may need to roughen the mating surfaces.
There is water in the fixture.
There is water in
the fixture.
There is water in
There is water in
the fixture.
the fixture.
Remove all components within head. Dry thoroughly. Verify all extrusion seams are flush. Spray
sealant (Permatex Form-A-Seal Leak Repair) or use RTV 108 along seams. Allow to dry.
Inspect gaskets and replace.
Verify the watertight cable fittings are in place and RTV»d.
If conduit is used a water tight seal must be used to block any opening.
Fixture does not strike.
Fixture does not strike.
Fixture does not strike.
Fixture does not strike.
For Composer Units:
For Composer Units:
For Composer Units:
For Composer Units:
Verify power to the fixture.
If the fixture has the Remote Strike feature:
Check CPU LEDs. Amber LED should be on solid, green LED should be flashing.
If amber is not lit, check or replace power supply.
If amber is on and the green LED is not flashing, replace CPU.
If amber is on and green is flashing, continue to the next line.
Disconnect power to the fixture and replace lamp.
Inspect high voltage connections inside the stanchion. Replace or repair as necessary.
Replace igniter and/or lamp lead wires.
For DMX units:
For DMX units:
For DMX units:
For DMX units:
Verify power to the fixture.
Check power supply LED. LED should be on solid.
If LED is not lit, check or replace power supply.
If LED is on , continue to the next line.
Disconnect power to the fixture and replace lamp.
Inspect high voltage connections inside the stanchion. Replace or repair as necessary.
Replace igniter and/or lamp lead wires.
IRID 110
AR500 Troubleshooting Guide
AR500 TROUBLESHOOTING GUIDE
AR500 TROUBLESHOOTING GUIDE
AR500 TROUBLESHOOTING GUIDE
AR500 TROUBLESHOOTING GUIDE
Revised: 7/27/2000
IRID 110
IRID 110
IRID 110
IRID 110
Page 1 of 3

Advertisement

loading

Summary of Contents for ETC Irideon AR500

  • Page 1 IRID 110 IRID 110 IRID 110 IRID 110 AR500 TROUBLESHOOTING GUIDE AR500 TROUBLESHOOTING GUIDE AR500 TROUBLESHOOTING GUIDE AR500 TROUBLESHOOTING GUIDE Fixture does not retain focus. Fixture does not retain focus. Fixture does not retain focus. Fixture does not retain focus. •...
  • Page 2 Fixture does not change certain colors. Fixture does not change certain colors. Fixture does not change certain colors. Fixture does not change certain colors. • For Composer units, set thumb wheels on CPU to «00». For DMX units, set thumb wheels to «990.» Self test will be enabled.
  • Page 3 For DMX units: For DMX units: For DMX units: For DMX units: • Verify data connections are good. Red LED blinking slowly indicates unit is not receiving data. • Check for swapped or disconnected data + and data - outside and inside the unit. •...