Page 2
SL-68 Hand wired The Suhr SL-68 is a hand wired, all-tube 100-watt head that delivers a broad range of classic and modern tonalities associated with British amplifiers of the late ® 60’s; from smooth and punchy clean to crunch all the way to full-bore hi-gain overdrive rich in harmonics and sustain.
Page 3
The Bass control adjusts the low end, turning it clockwise increases Power The Power Select Switch offers the following three-positions: OFF, Bass: the amount of low frequencies in your tone. HI & LOW power modes. Selector • OFF: Amplifier’s power mains are switched off Switch: •...
Page 4
Speaker Outputs: Bridging or Jumping the Channels: Two loudspeaker outputs wired in parallel with 3-way impedance The most common way to perform this is to plug your guitar into the selector switch for 4Ω, 8Ω & 16Ω. top (high sensitivity) input of Channel I and then run a short instrument patch cable from Channel I’s bottom (low sensitivity) IMPORTANT: To avoid serious damage to your amplifier, we input to the top (high sensitivity) input of Channel II.
Page 7
Rear Panel: Master Volume, 2- Speaker outputs, Impedance selector (4Ω, 8Ω, & 16Ω), HT Fuse, Mains AC Inlet and Mains Fuse Dimensions: tbd Weight: tbd Accessories: tbd WARRANTY FOR SUHR AMPLIFIERS AND ELECTRONIC PRODUCTS: For warranty information on the Suhr SL68 as well as all other Suhr products, please visit, https://www.suhr.com/warranty/...
Need help?
Do you have a question about the SL-68 and is the answer not in the manual?
Questions and answers