BLOTZ B10-ME-009 Manual

10mm middle east #9

Advertisement

10mm Middle East #9
B10-ME-009
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the two wall pieces and shelter roof from
the sprue.
Take the wall and roof piece shown.
Take the long side wall, roof piece and short wall.
Remove the long rear wall, roof and wall piece
from the sprue.
Assemble them as shown above.
Attach them to your model.
Add the side wall followed by the roof and short wall.
Add the wall piece, followed by the roof and rear wall.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B10-ME-009 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BLOTZ B10-ME-009

  • Page 1 10mm Middle East #9 B10-ME-009 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
  • Page 2 Take the long side wall, roof and inner wall. Attach the inner wall, followed by the roof and long side wall. Add the front wall. Take the three doors (if required) Glue one inside each doorway. Glue the model to its base. Take the gates and support piece.
  • Page 3 The finished model.

Table of Contents