Rightline Gear 100605 Directions

Directions For: Saddlebag Car Clips

The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Add the Saddlebag Car Clips (Fig 1) to the side straps of
the Rightline Gear Cargo Saddlebag to attach the carrier
to vehicles WITHOUT a roof rack (Fig 2).
Fig 1
1- Place the Cargo Saddlebag top side up. Extend one of
the long side straps out. Make sure the strap is not twisted
(Fig 3 and Fig 4).
Top Side
Fig 3
Strap End
Tri-glide
Fig 4
Fig 2
Male
Buckle
Pad
Strap
2-Remove the male buckle from the strap. Make sure the
other parts are positioned as shown (Fig 5).
Strap End
Tri-glide
Fig 5
3-Add the Saddlebag Car Clip and the male buckle onto
the strap (Fig 6). Make sure the strap goes through the
correct side of the buckle (Fig 6 Close-Up)
Strap End
Pad
Tri-glide
Fig 6
Saddlebag
Car Clip
Fig 6 Close-Up
4-Run the strap back through the buckle, the Saddlebag
Car Clip, the pad, and the tri-glide. (Fig 7).
Strap End
Tri-glide
Fig 7
5-Repeat steps 1-4 for the second long side strap.
Male
Buckle
Pad
Strap
Strap
Male
Saddlebag
Buckle
Car Clip
Male
Buckle
Grooves
Male
Pad
Buckle
Strap
Saddlebag
Car Clip