Woods RD6000-2, RD7200-2, RD8400-2 Operator's Manual page 33

Install Quick Hitch Kit (Optional)
NOTE: Figure 38 shows RM660, other models use the
same assembly instructions.
NOTE: This kit allows mower to fit only Cat. 1 standard
ASAE quick hitch.
5
5
10 0
7
8
9
5
1
3
1/2" x 4-3/4" HHCS
1. Offset link, .38 x 2 x 25.88 (A-frame bars)
2. 38" Long chain
3. Sleeve, .91 x 1.44 x 1.25
4. 1/2 NC x 6 Cap screw
5. 1/2 Flat washer
6. Sleeve, .5 x .75 x 3.38
7. 1/2 NC Flange lock nut
8. Sleeve, .875 x 1.125 x .593 HT
9. 7/8 Flat washer
10. Sleeve, .81 x 1.25 x 1.81
Figure 38. Quick Hitch Kit Installation
1. Attach offset link (1) to mounting pins, using 7/8"
sleeve (8) and flat washer (9). Do not tighten
hardware.
2. Attach upper end of offset link to pivot link, using
flat washer (5), sleeves (6 & 10), flange lock nut
(7), and 1/2" x 4-3/4" cap screw.
3. Remove rear offset links and replace with chains
(2). Cut to required length.
4. Attach chain to top of A-frame as shown, using cap
screw (4), flat washer (5), and nut.
5. Attach opposite end of chain (2) to rear mower
frame as shown.
MAN0180 (Rev. 1/7/2005)
A
5
5
4
2
CD6080A
6. Cut chain to length (RD6000 - 40 inches, RD7200
45 inches, RD8400 - 50 inches). Vary length
slightly as desired. Twist chain to make finite
adjustments in length until unit lifts level.
NOTE: Not do bottom out the drive on front of
deck.
7. Install sleeve (3) on mounting pins and retain with
klik pin.
Install Front Roller (Optional)
1. Insert four carriage bolts (5) through the front
mower frame from inside out.
2. Place roller bracket (8) over bolts; then install
flange whiz nuts (6) on bolts and tighten.
3. Place front roller (9), two bearings (10), spacer (7)
and two SAE flat washers (4) between roller
bracket as shown in Figure 39.
4. Insert cap screw (3) through bracket and roller.
5. Secure with flanged lock nut (2). Do not
overtighten, roller must spin freely.
2
4
10
9
7
CD6158
2.
1/2 NC Flanged lock nut
3.
1/2 NC Flanged lock nut
4.
1/2 Flat washer SAE
5.
3/8 NC x 1 Carriage bolt
6.
3/8 NC Flanged whiz nut
7.
Spacer, .75 x 6.62
8.
Bracket, front roller
9.
Roller, 4 x 7.37
10.
Bearing
Figure 39. Front Roller Installation
Assembly 31
6
5
8
3
10
4