Woods 7000, 7192, 7194, 7195, 7200, 7205 Manual page 39

Assembly Instructions Cont'd
Install Rear Lift Bars
1. Thread jam nut (3) onto upper rear lift bar (1) until
it bottoms out.
2. Thread upper rear lift bar into lower rear lift bar (2)
to obtain the 8-1/4" dimension shown.
3. Hand tighten jam nut against lower rear lift bar.
4. Place washer (6) and sleeve (5) over bolt (7) and
insert through lower rear lift bar (2) and rear lift
bracket (8). Secure with flanged locknut (4).
5. Repeat procedure for opposite side.
1. Upper rear lift bar
2. Lower rear lift bar
3. 1/2" Jam nut
4. 1/2" Flanged locknut
5. 1/2 x 3/4 x 1/2" Sleeve
6. 1/2" Flat washer
7. 1/2 x 1-1/2" Bolt
8. Rear lift bracket
Install Front Caster Wheel
1. Insert sleeve (68) through wheel (6).
2. Place washer (63) on bolt (70) and insert through
yoke (31) and sleeve in wheel.
3. Tighten flanged locknut (65) until yoke (31) con-
tacts both ends of sleeve (68).
4. Check that wheel turns freely. Loosen and
retighten if necessary.
5. Repeat procedure for opposite front caster wheel.
6. Caster wheel
31. Wheel yoke
63. 1/2" Flat washer
65. 1/2" Flanged locknut
68. 1/2 x 3/4 x 3-3/8" Sleeve
70. 1/2 x 5" Bolt
MAN0137 (9/14/01)
Figure 31 Rear Lift Bar Installation
Figure 32 Front caste Wheel Installation
Assembly 37