Related Manuals for FlaktWoods VEKA ver C
Summary of Contents for FlaktWoods VEKA ver C
- Page 1 VEKA ver C ™ Air ComforT Supply Air unit VeKA ver C » InstallatIon and maIntenance...
-
Page 2: Table Of Contents
Supply air unit VEKA Installation and Maintenance ContEnt Page 1. SAfEty inStruCtionS ................3 2. inStAllAtion 2.1 Storage ......................4 2.2 Lift and transport ..................4 2.3 Suspension from the ceiling ............4 2.4 Suspension on wall ................4 2.5 Installation of shut-off damper VEVA ...........4 2.6 Connection to duct ................ -
Page 3: Safety Instructions
Installation and Maintenance Supply air unit VEKA 1. SAfEty inStruCtionS opErAtion of Air hAndling unitS And ACCESSoriES wArning Before taking the air handling unit into operation fit any unused connections with Fan and short filter (cc = 12) protective mesh. In addition, all electrotechnical and mechanical safety devices must be installed before taking the air handling... -
Page 4: Installation
Supply air unit VEKA Installation and Maintenance 2. inStAllAtion 2.1 StorAgE The unit has to be stored under protective roof. Keep the packa- ging on. 2.2 lift And trAnSport Fig. 3. Fastening irons of the kind illustrated in fig. 3 can be used instead of hangers. -
Page 5: Connection To Duct
Installation and Maintenance Supply air unit VEKA 2. inStAllAtion 2.6 ConnECtion to duCt 2.8 CondEnSAtE drAinAgE of Air CoolEr Air cooler drainage connection external Ø 15 mm for connection M8 (not supplied) Flexible connection VEKZ-51 to a water trap with a height of at least 60 mm. 2.9 ElECtriCAl ConnECtion of fAnS If the unit is ordered with built-in controlsystem Curo, the fans are pre-wired. -
Page 6: Checks Before Start Up
Supply air unit VEKA Installation and Maintenance 2. inStAllAtion / 3. StArting / 4. Air flow indiCAtor 2-wAy VAlVE VVg 3 StArt up The flow is increased by turning the spindle inwards, the flow is After electrical wiring and connection of external components, the reduced by moving the spindle outwards. -
Page 7: Electrical Heater Veek
Installation and Maintenance Supply air unit VEKA 5. ElECtriCAl hEAtEr VEEK 5.2 ConnECtion 5.1 inStAllAtion 1. Installation may only be carried out by a qualified installer. 1. The VEEK duct heater is connected to the pressure General regulations must be observed in conjunction with in- side of the VEKA hot air unit. stallation and connection. -
Page 8: Overheating
Supply air unit VEKA Installation and Maintenance 5. ElECtriCAl hEAtEr VEEK 5.2 ConnECtion, Cont. 5.3 oVErhEAting Proceed as follows if the overheating protection with manual VEEK resetting trips: 0 - 10 V 1. Intervention in the electrical heater, such as removing the –... -
Page 9: Maintenance
Installation and Maintenance Supply air unit VEKA 6. MAintEnAnCE 6.1 filtEr rEMoVAl of fAn 1. Disconnect the control cable with fittings. The VEKA unit requires regular service of the filter in order to function without problems. A contaminated filter can cause trip- ping of the overheating protection. See service chart, section 6.3. 6.2 fAnS MAintEnAnCE 2. -
Page 10: Service Chart
Supply air unit VEKA Installation and Maintenance 6. MAintEnAnCE 6.3 SErViCE ChArt In environments with a high level of dust in the supply air or ex- haust air, inspection of the air handling unit shall be performed at inSpECtion intErVAlS more frequent intervals. -
Page 11: Declaration Of Incorporation Of Partly Completed Machinery
Installation and Maintenance Supply air unit VEKA 7. dEClArAtion of inCorporAtion of pArtly CoMplEtEd MAChinEry Bilaga II B ENCLOSURE II B Försäkran för inbyggnad av en delvis fullbordad maskin Declaration of incorporation of partly completed Machinery med EG:s Maskindirektiv, 2006/42/EC, Annex 2B with the EU Directive for Machinery, 2006/42/EC, Annex 2B överensstämmelse med EG:s EMC Direktiv, 2014/30/EU in accordance with the EU EMC Directive, 2014/30/EU... -
Page 12: Disposal
– The units casing may contain condense- or mineral wool insulation sandwiched between the inner and outer shell. – The remaining parts shall be sorted as metallic. – Lamps and fluorescent lights. See www.flaktwoods.com/ecodesign for recycling instructions. Fläkt Woods 9964 GB 2016.09.07 Specifications are subject to alteration without notice... - Page 13 Installation and Maintenance Supply air unit VEKA Fläkt Woods 9964 GB 2016.09.07 Specifications are subject to alteration without notice...
- Page 14 , Optivent ® , Optimix ® , Econovent ® and Cleanvent ® are well-known and trusted by customers all over the world to deliver high quality and energy efficient solutions. » To learn more about our offering and get in contact with your nearest sales representative please visit www.flaktwoods.com...