Important Safety Instructions - AT&T ISDN 8510T Instructions For Installing Or Replacing

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment and installing this D-Kit, the
following safety precautions should always be followed to reduce the risk
of fire, electric shock, and injury to persons.
Read and understand all instructions.
Follow all warnings and instructions marked on the telephone.
To reduce the risk of electrical shock, disconnect all cords before
opening the telephone to install this D-Kit.
This telephone can be hazardous if immersed in water. To avoid the
possibility of electrical shock, do not use the telephone while you are
in the bathtub or shower, or when you are wet. If you accidentally
drop the telephone into water, do not retrieve it until you have first
unplugged the line cord from the modular wall jack. Do not reconnect
the telephone until it has dried thoroughly.
Avoid using the telephone during electrical storms in your immediate
area. There is a remote risk of electric shock from lightning. Urgent
calls should be brief. Even though protective measures may have
been installed to limit electrical surges from entering your home or
business, absolute protection from lightning is impossible.
If you suspect a natural gas leak, report it immediately, but use a
telephone away from the area in question. The telephone's electrical
contacts could generate a tiny spark. While unlikely, it is possible
that this spark could ignite heavy concentrations of gas.
Never push objects of any kind into the telephone through housing
slots since they may touch hazardous voltage points or short out
parts that could result in a risk of electric shock. Never spill liquid of
any kind on the telephone. If liquid is spilled, however, refer servicing
to proper service personnel.
Slots and openings in the housing and the back or bottom of the
telephone are provided for ventilation to protect it from overheating;
these openings must not be blocked or covered. The openings
should never be blocked by placing the telephone on a sofa, rug, or
other similar surface. This product should not be placed in a built-in
installation unless proper ventilation is provided.
The telephone should be operated only from the type of power
source indicated on the marking label. If you are not sure of the type
of power supply being used, contact a qualified service person.
Do not allow anything to rest on the power cord. Do not locate this
product where the cord will be abused by persons walking on it.
Do not overload the AC wall outlets and extension cords as this can
result in risk of fire or electric shock.
2