AT&T ISDN 8510T Instructions For Installing Or Replacing page 11

Blank for round
8-pin connector
FIGURE 7 The Connector Hole Blanks on the Rear of the 8510T Desktop Stand
With your thumbs, push, from the outside of the stand, on the two
2
connector hole blanks at the same time. As the blanks loosen, push
them back and then up. The blanks that you remove should look like
the ones in Figure 8.
Break the blanks in half. Figure 8 shows the point at which the
3
blanks should be separated. Discard the RS232 portion of the blank
which covered the RS232 connector hole.
Blank for
RS232 connector
11