Rain Bird ESP-LXD Programming Manual page 28

Hide thumbs Also See for ESP-LXD:

Barcode Scanning Pen Setup

Setup Barcode #1

Setup Barcode #2

Set Up Barcode Scanning Pen

NOTE: The optional barcode scanning pen must be purchased

separately. Rain Bird recommends using a Unitech MS100-2

barcode pen with 9 pin (female) serial connector. Go to www.ute.

com for more details. To set up other brands of barcode scanning

pens, see the manufacturer's setup instructions.

Scan Setup Barcode # 1 barcode (above) lengthwise as shown.

You'll hear audible beep(s) to confirm that the first scan was

successful.

ESP-LXD Controller

Then scan Setup Barcode # 2 and again you'll hear audible beep(s)

to confirm that the second scan was successful. The barcode

scanning pen is now ready for use.

NOTE: If you do not hear audible beep(s) to confirm scan success

then repeat the process until you hear the beeps.

Test Barcode Scanning Pen

Turn the controller dial to ETM/IQ/PBC Settings.