Table of Contents
Advertisement
DIY Mode Setting
When you switch to the DIY mode, the flosser will in the last used DIY mode status. To
change the working status of the DIY mode, follow the below instructions:
1.
In the DIY mode work, press the On/Off button again.
2.
The working status will rise from the lowest water pressure to the highest water
pressure mode and stay at the highest water pressure mode temporarily. The
water will circulate according to this mode.
3.
Release the On/Off Button to indicate the selection of the new working status
(new status is locked). The system maintains and work under the new working
status.
First-time Usage Recommendations
When you use the flosser for the first time or after a long time, follow the below instructions:
1.
Press the On/Off button and wait for a few minutes for the Jet Tip to discharge
water. Turn off the flosser,
2.
Pull the inner water tank until you see the "OK" mark and also hear a "click" sound.
This indicates the inner water tank has been pulled to the right position. If not,
water will leak from the inner water tank.
3.
Open the water inlet cover to fill water into the water tank.
4.
After adding an adequate amount of water into the tank, push the inner water
tank back. Press On/Off button to turn on the flosser.
Notes:
•
•
When using for the first time, ensure the flosser is set to Soft
mode.
Point the jet tip towards the gap between your teeth.
Advertisement
Table of Contents
