Table of Contents
Advertisement
Charging the Flosser
1.
Charge the flosser for 8 hours before the first-time use.
2.
Connect the USB cable to any appropriate USB adapter (5V, 1A) or USB port.
3.
Plug another side of the USB cable into the charger and then plug the charger into
a power socket.
4.
When charging, the Charging Indicator Lights are red and are slowly flashing.
When fully charged, the charging indicator will turn green and will remain the
same until the charger is removed.
Using Water Tank
•
Pull the inner water tank until you see the "OK" mark. Now you can fill the water to
100%.
Fully Pulled
•
Do not push back the inner water tank if the water tank is overflowing.
•
Do not push back the inner water tank if the flosser is powered on.
•
Do not push back the inner water tank if water is not used up in the water tank.
Follow the below instructions:
1.
Pull the inner water tank until you see the "OK" mark.
2.
Open the water inlet cover to fill water into the water tank.
3.
Press On/Off button to turn on the flosser and to use it. Once completed, press the
button again to turn off the flosser.
Half Pulled
Unpulled
Advertisement
Table of Contents
