Cid - AEG ID ACM 9 Manual

Manual ACM 9 - ARE i9 release

3.4.6 CID

CID – Filter same UID numbers to transmit only once via interface
CID is used to filter multiple read transponder UID to transmit only once via interface. There needs to be one different
Transponder UID read before the same number will be transmitted again.
Parameters: 0 – no filter function
Input format: CID<SP>1<CR>
Hex: 43
ASCII: 'C'
Output (example): 0x1<CR>
Hex: 31
ASCII: '1'
3.4.7 CN
CN – Filter no read from being transmitted via interface.
CN is used in those cases, where no read information 'XXXXXXXX' is not to appear on the interface. Only valid transponder
UID will be transmitted.
Parameters: 0 – no filter function
Input format: CID<SP>1<CR>
Hex: 43
ASCII: 'C'
Output (example): 0x1<CR>
Hex: 31
ASCII: '1'
Manual ACM9_ARE i9 release V02.docx
| 1 – filter same chip UID as previously read
49 44 20
'I' 'D' <SP>
0D
<CR>
| 1 – filter no read information from being transmitted
4E 20 31
'N' <SP> '1'
0D
<CR>
31
'1'
Version: 02
Page: 33 / 43