Tor - AEG ID ACM 9 Manual

Manual ACM 9 - ARE i9 release
3.2.4 GT
GT – Get Tag
GT is used to retrieve the transponder UID.
Input format: GT<CR>
Hex: 47
ASCII: 'G'
Output (example): 1234567812345678 <CR>
Hex: 31
ASCII: '1'

3.2.5 TOR

TOR – Timeout Reading
After a read is triggered by GT, TOR is a time during which ARE i9 continuously tries to read a transponder UID without
the need to be triggered by the host again. This limits bus traffic considerably. Once a successful read is performed,
continuous reading stops immediately regardless of time and the transponder UID is transmitted to the host. If reading
is not successful, a no read (XXXXXXXXXXXXXXXX) is sent to the host after TOR time has expired.
The chosen parameter for TOR is sent as acknowledgement.
Input format: TOR<SP>50<CR>
Hex: 54
ASCII: 'T'
Output (example): 50 <CR>
Hex: 35
ASCII: '5'
Parameter:
PARAMETER
0
1
2
...
255
A TOR value of 50 equals 50 x 100ms = 5000ms = 5 sec.
It is recommended to set TOR value to the amount of time it takes in a dynamic situation for the transponder to travel over
ARE i9. This maximizes the number of possible reads, in order to compensate for EMV noise in the vicinity.
Manual ACM9_ARE i9 release V02.docx
54 0D
'T' <CR>
32 33 ...
'2' '3' ...
4F 52 20
'O' 'R' <SP>
30 0D
'0' <CR>
FUNCTION
limits the reading process duration to exactly one reading cycle
limits the reading process duration to maximum 1 times 100ms
limits the reading process duration to maximum 2 times 100ms
limits the reading process duration to maximum 255 times 100ms
... 38 0D
... '8' <CR>
35 30
'5' '0' <CR>
Version: 02
Page: 18 / 43
0D