AirLive WL-5460APv2 Faq

I have a remote AP ,how to extend the coverage of the remote AP by

WL-5460APv2?

Please get into the web management of WL-5460APv2 and set WL-5460AP2 as

Universal Repeater mode.

When you configure WL-5460APv2 as Universal Repeater mode, WL-5460APv2 could

connect to the remote AP with AP mode.

While WL-5460APv2 and the Remote AP are connected, they must meet the

followings:

1. WL-5460APv2 support 802.11b+g mode, so Remote AP should also support

802.11b/g mode.

2. The Channel and security setting of WL-5460APv2 is the same as the Remote AP.

3. The SSID of Extended Interface is also the same as the Remote AP

Please follow the following to connect WL-5460APv2 to Remote AP:

1. Please power on WL-5460APv2 and connect your PC to the LAN port 1 of

WL-5460APv2 wired.

2. Please get into the web management of WL-5460APv2.

3. Please set WL-5460APv2 as Universal Repeater mode and set the security

settings as the same as Remote AP .

Table of Contents

Need help?

Do you have a question about the WL-5460APv2 and is the answer not in the manual?

Page 1 1. WL-5460APv2 support 802.11b+g mode, so Remote AP should also support 802.11b/g mode. 2. The Channel and security setting of WL-5460APv2 is the same as the Remote AP. 3. The SSID of Extended Interface is also the same as the Remote AP Please follow the following to connect WL-5460APv2 to Remote AP: 1.
Page 2 4. Please use the Site Survey function to connect the SSID of Remote AP from the SSID table. 5. If WL-5460AP2 connect to the remote AP successfully, it would show the below picture: 6. After you connect WL-5460APv2 to Remote AP successfully, please connect wireless client to the SSID of WL-5460AP.