AirLive WL-5460AP Manual

AirLive WL-5460AP Manual

Emergency repair for 11g ap
Hide thumbs Also See for WL-5460AP:

Advertisement

Emergency Repair with AirLive 11g AP
Applicable Models:
The following table shows how to judge the state of the AP by looking at its LED.
Model
WL-5450AP,
WLA-5460AP,
WL-5470AP,
WL-5470POE
Firmware Crashed: You can use the Emergency upgrade procedure in this section
to restore the AP
Bootloader Crashed: You need to send the unit back to AirLive for repair.

Emergency Firmware Upgrade

The AirLive 11g Access Points features emergency firmware upgrade function that
can restore your AP from a firmware crashed. If you can't access your AP
anymore, please first try to restore the setting to default by holding the RESET
button (in the back) for more than 5 seconds. You should be able to find the AP
at 192.168.100.252. If you can't find it and the status LED stays RED after
power-on for 10 minutes, then please perform the emergency upgrade.
AirLive Wireless Workshop
WL-5460AP, WL-5450AP, WL-5470AP, WL-5470POE, WH-5420CPE
LED Status Table
Normal Condition
WLAN LED will
light up
Status LED will be
off
Firmware Crashed
Status LED stay
constantly on
Bootloader Crashed
Both Status and
WLAN LED are off
Page. 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WL-5460AP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AirLive WL-5460AP

  • Page 1 Firmware Crashed: You can use the Emergency upgrade procedure in this section to restore the AP Bootloader Crashed: You need to send the unit back to AirLive for repair. Emergency Firmware Upgrade The AirLive 11g Access Points features emergency firmware upgrade function that can restore your AP from a firmware crashed.
  • Page 2 How Emergency Upgrade Works? The AirLive 11g AP’s flash memory is divided into “firmware” and “bootloader” area. The bootloader area is protected from writing and has a built-in emergency web server. Therefore, the AP can be recovered from emergency web server after a firmware crash.
  • Page 3 Click on “UPGRADE” button. After upload succeed, it will shows the message "Upload OK, Please wait...". Do not touch the AP or PC until the upgrade is completed. 10. Wait for AP to finish reboot. The status LED will go off after AP finish reboot. AirLive Wireless Workshop Page. 3...
  • Page 4 11. Change your PC’s IP address back to 192.168.100.100 12. Open the web browser, and type “192.168.100.252”. You should see the following screen. AirLive Wireless Workshop Page. 4...

This manual is also suitable for:

Wl-5450apWl-5470poeWl-5470apWh-5420cpe

Table of Contents