Cutting Crown Molding - Bosch 4405 Operating/Safety Instructions Manual

Crown Molding Angled to
Table and Fence
• The advantage to cutting in this position is that
no bevel setting is required. Cutting is done with
45° miter angle.
• The maximum crown molding width that can be
cut and angled to table and fence is 4-1/4". The
preferred method for cutting crown molding with
this saw is with the molding laying flat on the
table at a maximum width of 10". Crown stops
can be purchased as an accessory.
Follow these instructions for cutting crown
molding angled to table and fence.
1. Position the molding so the bottom (part which
is installed against the wall) is against the fence.
2. Set the miter angle using Chart 2. Tighten the
miter lock knob (Figure 34).
3. Support crown molding against the fence (see
"Body and Hand Position" on page 19.)
4. Follow the procedures for chop or slide cut (see
page 24).
CROWN MOLDING CUTS - CUTTING METHOD #2 - ANGLED TO TABLE AND FENCE
1
MAX. SIZE: 4- / "
4
BOTTOM EDGE
F
E
52º
N
C
E
TABLE
TYPE
OF
CUT
INSIDE CORNER
A
LEFT SIDE
SAVE RIGHT END OF CUT
B
RIGHT SIDE
SAVE LEFT END OF CUT
Saw Operations
52º CEILING
38º
W
A
L
ANGLES OF U.S.
L
STANDARD MOLDING
MITER BEVEL
(TABLE) (TILT)
SETTNING SETTING
RIGHT
45º 0º
LEFT
45º 0º
30.
Figure 34. Crown Molding Angled to
Table and Fence
5. Wait until blade comes to a complete stop
before returning head assembly to the raised
position and/or removing workpiece.
NOTE: ALWAYS TAKE A TEST CUT USING
SCRAP TO CONFIRM CORRECT ANGLES.
INSIDE
CORNER
TYPE
OF
CUT
OUTSIDE CORNER
C
LEFT SIDE
SAVE RIGHT END OF CUT
D
RIGHT SIDE
SAVE LEFT END OF CUT
C
D
A
B
OUTSIDE
CORNER
MITER BEVEL
(TABLE) (TILT)
SETTNING SETTING
RIGHT
45º 0º
LEFT
45º 0º