Norbord CSS791 Assembley Manual

Panels
Before you start . . .
WARNING: Installation should be performed by a competent person only. This product could be dangerous if incorrectly installed. Check the pack and
make sure all the components are included - if not, call the Manufacturers' Helpline on 01769 575500 and their team will get things sorted. When you are
ready to start make sure you have the right tools to hand, plenty of space and a clean dry area for building. Don' t rush, read the instructions first and run
through the sequence before you begin. Assembly should be done in the stages shown in the following diagrams, constructing one unit at a time and keeping
fittings together to avoid loss. Lay large panels on the floor using the packaging for protection. Do not over tighten screws.
Cleaning - Use mild soap and water only. Do not use abrasive cleaners.
Video assembly guides can be viewed at www.mycabinetguide.co.uk
1
Marking the stay fixing positions on the
cabinet (standard doors only)
If you have chosen framed doors, refer to the instructions
supplied in the separate hinge pack for stay fixing instructions.
TOP OF CABINET
98mm
Drill 2x3mm pilot holes
for door stay screws to
44mm
inside face of Bridging
Cabinet Side Panel
140mm
LH SIDE PANEL
34mm
Hardware
8 x A
6 x B
15mm
8 x
R
4 x
25mm
8 x
4 x
D
30mm
(standard
Hinges
Wall Fixings
doors only)
I
2 x
L
2 x
M
2 x
K
2 x
2 x N
1 x P
2
Marking the stay fixing positions on the door (standard doors only)
Drill inside face of Bridging Cabinet Door with 2x Pilot Holes at positions shown.
This stay is designed for LH fixing only. However, if you wish to fit it to the RH side,
the 34mm dimension will need to be reduced to 14mm.
NOTE: Some standard door ranges have different hinge fixing positions for the bridging
unit door, which may require you to drill some extra holes before assembling this unit.
Check your bridging unit door pack before assembling this unit. If any extra drilling is
required, you will find instructions in the door pack on how to do this.
600mm
WIDE
WALL
Bridging Cabinet
Tools required
Cross Head Screwdriver
G
Drill & Drill Bits
H
To construct
cabinets & legs
3mm
PVA Wood Glue
Pliers x 2
Hammer
Spirit Level
Drill 2 x 3mm
32mm
pilot holes
for door stay
screws
To fit
handles
4.5mm
108mm
34mm
CSS791 08/13