Norbord WALL CSS890 Assembly Manual

Panels
Before you start . . .
WARNING: Installation should be performed by a competent person only. This product could be
dangerous if incorrectly installed. Check the pack and make sure all the components are included -
if not, call the Manufacturers' Helpline on 01769 575500 and their team will get things sorted.
When you are ready to start make sure you have the right tools to hand, plenty of space and a clean
dry area for building. Don' t rush, read the instructions first and run through the sequence before you
begin. Assembly should be done in the stages shown in the following diagrams, constructing one unit
at a time and keeping fittings together to avoid loss. Lay large panels on the floor using the
packaging for protection. Do not over tighten screws.
Cleaning - Use mild soap and water only. Do not use abrasive cleaners.
Video assembly guides can be viewed at www.mycabinetguide.co.uk
1
Insert and as shown, repeat for opposite side panel.
Attach wall hanging units
shown using screws . Please note the back of the hanging
bracket does not line up with the back panel groove.
Apply a small
droplet of glue
to hole before
inserting
Hardware
8 x
8 x
2 x
4 x
4 x
Wall Fixings
2 x
2 x
using the pre-marked holes as
1
A 10 x E
B
15mm
8 x G
R
25mm
H
8 x
D
30mm
C
40mm
(standard
Hinges
doors only)
L I
4 x
K
4 x M
4 x N
2
2
3
800mm
WIDE
WALL
Cabinet
Tools required
Cross Head Screwdriver
Drill & Drill Bits
To construct To fit
cabinets & legs handles
3mm 4.5mm
PVA Wood Glue
Pliers x 2
Hammer
Spirit Level
Note: If you
Inside groove
to back
are using
Left side panel
a colour
matched
end panel, use
this to replace
the identically
Right side panel
sized side
panel supplied
within this
pack.
as shown. It's IMPORTANT
Insert
that arrow points to outside edge.
CSS890 06/10