Norbord 1000mm PAN DRAWERS Assembly Manual

ASSEMBLY GUIDE
*** IMPORTANT INFORMATION ***
BEFORE YOU START
Installation should be performed by a competent person
only. This product could be dangerous if incorrectly installed.
Check the pack to ensure all of the components are included.
When you are ready to start, make sure that you have all of
the correct tools to hand, have plenty of space, and that the
area for building is clean and dry.
Do not rush! Read these instructions first and run through
the sequence before you begin. Assembly should be
carried out in the steps shown in the following diagrams,
constructing one unit at a time and keeping fittings together
to avoid loss. Lay large panels on the floor using the
packaging for protection. Do not overtighten screws, as this
may damage the cabinet.
If any items are missing, or problems arise with fitting,
please call the Manufacturers' Helpline on 01769 575500.
To clean - use mild soap and water only.
Do not use abrasive cleaners.
STEP 1:
Before fitting drawer runners to base end
panels, check that you have a 'pair' of runners
for right and left hand operation. Pull top
metal runner fully towards you to establish
'handing'.
The highlighted hole positions must be used,
as detailed in Fig 1, (RH panel shown).
Fix the RH runner to the RH end panel
BS
using 4 x screws BE , and then repeat for the
LH runner on the LH end panel.
BR
1000mm PAN DRAWERS (STANDARD & CURVED)
4 x
2 x BR BF
LH Drawer Runner
4 x
BG
2 x
BS RH Drawer Runner
16 x BE
4 x BT 36 x D
2 x 12 x
BV BM
Please use scissors to open the bag of fittings and then empty the contents into a bowl, so that they do not get lost!
TOP OF PANEL
BS
RH END PANEL SHOWN
BS
FIGURE. 1
HARDWARE:
2 x BJ
Euro Screw
2 x
BK
15mm
2 x
BN
Euro Screw
4 x
BP
15mm
25mm
6 x BL
30mm
50mm
STEP 2:
The toothed rails
50mm shown, using 3 x
the drawers, in order to stabilise the drawer
itself, during operation.
The cogs fitted to the back of the drawers
should then run smoothly along these rails.
BT
15mm
BT
4 x 4 x
BW BX
2 x LH drawer side
S
2 x
RH drawer side
T
2 x Metal Drawer Back
U
STEP 3:
Clip drawer sides
should be fitted, as
BT
screws each, before fitting back
D U
Turn Drawer upside down and slide Base
Panel
1
Secure with 2 x
D
T
NOTE: When building the curved pan
drawers, the drawer base
secured in place until after the drawer front
has been secured. This should ensure a
minimum gap between the drawer base and
the drawer front.
CSS 1624
03/16
MINIMUM TOOLS REQUIRED:
CROSS HEAD SCREWDRIVER
3 5
DRILL & DRILL BITS (3mm & 5mm)
TAPE MEASURE
PANELS:
1
Drawer Base
2 x
1
and to Metal drawer
S T
.
into position.
D screws per side.
D
D
D
1
S
U
should not be
1