Norbord CSS 793 Assembly Manual

Panels
Before you start . . .
WARNING: Installation should be performed by a competent person only. This
product could be dangerous if incorrectly installed. Check the pack and make sure all
the components are included - if not, call the Manufacturers' Helpline on 01769 575500
and their team will get things sorted. When you are ready to start make sure you have the
right tools to hand, plenty of space and a clean dry area for building. Don't rush, read the
instructions first and run through the sequence before you begin. Assembly should be done
in the stages shown in the following diagrams, constructing one unit at a time and keeping
fittings together to avoid loss. Lay large panels on the floor using the packaging for
protection. Do not over tighten screws.
Cleaning - Use mild soap and water only. Do not use abrasive cleaners.
1
Insert and as shown, repeat for opposite side panel.
Attach wall hanging units
shown using screws . Please note the back of the hanging
bracket does not line up with the back panel groove.
Apply a small
droplet of glue
to hole before
inserting
Hardware
8 x
8 x
2 x
4 x
4 x
Wall Fixings
2 x
2 x
using the pre-marked holes as
1
E
A 10 x
B
15mm
8 x G
R
25mm
8 x H
D
30mm
C
40mm
(standard
Hinges
doors only)
L 4 x I
K
M
4 x
4 x N
2
2
3
1000mm
WIDE
WALL
Cabinet
Tools required
Cross Head Screwdriver
Drill & Drill Bits
To construct To fit
cabinets & legs
handles
3mm
4.5mm
PVA Wood Glue
Pliers x 2
Hammer
Spirit Level
Note: If you
Inside groove
to back
are using
Left side panel
a colour
matched
end panel, use
this to replace
the identically
Right side panel
sized side
panel supplied
within this
pack.
as shown. It's IMPORTANT
Insert
that arrow points to outside edge.