Norbord CSS 805 Assembly Manual

ASSEMBLY GUIDE
Panels
2
4
1
3
2 x 1 x
1
Side Panels
2
1 x 1 x
Top Panel
Before you start . . .
WARNING: Installation should be performed by a competent person only. This product could be dangerous if incorrectly
installed. Check the pack and make sure all the components are included - if not, call the Manufacturers' Helpline on 01769
575500 and their team will get things sorted. When you are ready to start make sure you have the right tools to hand, plenty of
space and a clean dry area for building. Don't rush, read the instructions first and run through the sequence before you begin.
Assembly should be done in the stages shown in the following diagrams, constructing one unit at a time and keeping fittings
together to avoid loss. Lay large panels on the floor using the packaging for protection. Do not over tighten screws.
Cleaning - Use mild soap and water only. Do not use abrasive cleaners.
Video assembly guides can be viewed at www.mycabinetguide.co.uk
NOTE: The pull-out wire system
can be fitted to either side panel,
and is shown here fitted to the
RH side. For fitting instructions,
please refer to the assembly
guide supplied with the pull-out
wire system.
Hardware
8 x
8 x
10 x
2 x
12 x
Legs
2 x
3
Base Panel
4
Back Panel
1
Insert and as shown, repeat
for opposite side panel.
150mm
WIDE (Pull Out)
BASE
Cabinet
F
A 2 x
H
1 x
B
Pull Out
15mm
Wire System
(Boxed)
R
25mm
G
O Q P
2 x 1 x
S
1 x
1
Tools required
Cross Head Screwdriver
Drill & Drill Bits
To construct To fit
cabinets & legs handles
3mm
4.5mm
PVA Wood Glue
Pliers x 2
Hammer
Spirit Level
Apply a small
droplet of glue
to hole before
inserting