WARNING: Installation should be performed by a competent person only. This product could be dangerous if incorrectly installed. Check the pack and
make sure all the components are included - if not, call the Manufacturers' Helpline on 01769 575500 and their team will get things sorted. When you are
ready to start make sure you have the right tools to hand, plenty of space and a clean dry area for building. Don' t rush, read the instructions first and run
through the sequence before you begin. Assembly should be done in the stages shown in the following diagrams, constructing one unit at a time and
keeping fittings together to avoid loss. Lay large panels on the floor using the packaging for protection. Do not over tighten screws.
Cleaning - Use mild soap and water only. Do not use abrasive cleaners.
To protect your kitchen doors from any excess heat emitted by your oven, it is strongly recommended that an appropriate Oven Heat Deflector Kit is fitted
around the oven aperture in this unit. Suitable kits are available from B&Q and details can be found in the kitchen price list.
Video assembly guides can be viewed at www.mycabinetguide.co.uk
Page 1
ASSEMBLY GUIDE 600mm WIDE TALL Oven/Fridge Freezer Housing 900 Aperture 600 Aperture Fridge Freezer Oven Housing Oven Housing Housing Tools required Panels Hardware Cross Head Screwdriver 16 x Top Panel 32 x 15mm 12 x Drill & Drill Bits Base Panel 25mm 16 x Fixed Shelf...
Page 2
Connect base panel onto end panel as shown. Tighten clockwise Run small bead of glue Repeat for top panel in 8 positions. along all fixed shelves grooves Slide both back panels (supplied separately) into grooves. Note: the back panels will require trimming to the correct height behind the fixed shelves.
Page 3
To build a 50/50 or a 60/40 tall fridge freezer housing: Prepare the end panels (supplied as shown (8 positions). It's IMPORTANT Insert separately) by inserting that arrow points to outside edge. Top edge of panels as shown for both panels. Apply a small droplet of glue to hole before...
Page 4
Joining and Levelling Door hinges (standard doors only) of Cabinets Separate hinge from hinge plate if supplied attached. If you have chosen framed doors, refer to the instructions supplied in the separate hinge pack for frame fixing, fitting and adjustment of hinges. Affix hinge plate to cabinet using Insert door hinge...