Fridge Removal
The fridge is screwed into the SIDES of the furniture (standard fitting, but not a good
design, so care needed for removing and re-assemble, the screw lengths are different each
side and it is easy to go through the ply by mistake).
Left screw is in the lower position
•
Right screw is in the upper position
•
Prise off the caps shown below to find the screws hidden inside, well below the surface,
which makes them very difficult to get out (if they are not removed, they will scratch the
furniture as the fridge is pulled out.)
After removal, the fridge will pull directly out – remove the top drawer to help access. The
wires are long enough to get the fridge out. The fridge uses large soldered wires and
connections to ensure a small voltage drop as the fridge uses more electricity than
anything else.
Earth is located directly behind and above rear of fridge behind panel.
Water Pump
Positive Runs to pump (Orange), the negative (Black) is the switched wire via the tap.
Soldered connections are used. Earth is located directly behind and above rear of fridge
behind panel
Rear LED switches
Side switch:
26