DA-JB2300 INSTALLATION MANUAL
Mounting
Mount the junction box to the wall or mounting bracket as follows:
Wall
Junction Box
Wall Hole
3/4" Cap
1
Insert cables from external devices, network and power adapter to the junction box.
2
Mount the junction box to the wall or mounting bracket by using the screws.
• Use the provided guide pattern to check the distance between the screw holes if necessary.
• If you want to insert cables through the bottom of the junction box, remove the 3/4" cap and
attach it to the wall hole.
Rubber
Mounting
Bracket
Junction Box
Cable
4
Route the cable from the camera through the rubber and then junction box. Attach the rubber
onto the junction box.
5
Fix the cables using the cable clamp.
6
Connect the cables from external devices, network and power adapter to each port of the
camera.
This manual is intended for users of the DA-JB2300 junction box. It
includes instructions for mounting the DA-JB2300 junction box to a wall.
• This junction box is intended to be used with DC-E & DC-T
series model of camera. Do not use it with other models of
cameras.
• This installation should be performed by a qualified service
personnel in conformance to all local codes.
• You may need to reinforce the wall. If the wall is not strong
enough to support the camera, the camera may fall.
• Do not use this product for other purposes.
Bracket
Cable
Cable Clamp
Cable
Rubber
Junction Box
Junction Box Cable
Cable
Rubber
Junction Box
Bracket
Junction Box Cable