Gira 5110 00 Product Documentation page 31

Broadcast telegrams
physically addressed
telegrams
Telegrams RF -> TP
Group telegrams
Order No. 5110 00
block
filter
transmit unfiltered
block
transmit unfiltered
block
filter (depending on
target & coupler address)
Software "Media coupler / repeater"
i This setting should only be selected
in a KNX installation within the
context of system commissioning.
During normal operation of a KNX
system after commissioning, it is
always recommended to activate
the filter function of the group
telegrams in both communication
directions. This is realised by the
parameter settings "filter" (default
setting) or "lock".
All group telegrams will be blocked. No
group telegram can pass the media
coupler from TP to RF.
In accordance with the filter table
generated and programmed in the ETS,
group telegrams are either transmitted
or blocked selectively.
This parameter determines whether
broadcast telegrams are forwarded from
the higher-level TP line to the lower-
level RF line (routing TP -> RF).
All broadcast telegrams are transmitted.
All broadcast telegrams are blocked. No
broadcast telegram can pass the media
coupler from TP to RF.
This parameter determines whether
physically addressed telegrams are
forwarded from the higher-level TP line
to the lower-level RF line (routing TP ->
RF).
All physically addressed telegrams are
transmitted.
All physically addressed telegrams are
blocked. No physically addressed
telegram can pass the media coupler
from TP to RF. This means no RF
devices in the media coupler domain
can be programmed via the TP side!
Only physically addressed telegrams
with a target address matching the
media coupler area or line address are
forwarded. All other physically
addressed telegrams are blocked.
This parameter determines whether
group telegrams are forwarded from the
Parameters
Page 31 of 57