Delivery State - Gira 5110 00 Product Documentation
Rf/tp media coupler or rf repeater
Hide thumbs
Also See for 5110 00:
- Operating instructions (5 pages) ,
- Operating instructions manual (9 pages)
Table of Contents
Advertisement
4.2.3.6 Delivery state
Function in delivery state
In delivery state, the device is ready for operation as a media coupler. The device works as
follows with the configurations below:
-
Physical address: 15.15.0
-
Domain address: $FF FF FF FF FF FF
-
Configuration lock: inactive
-
Repeater function during use as media coupler: deactivated
-
Function of yellow status LED: deactivated
-
Filtering group telegrams (TP -> RF, RF -> TP): Filter (because no filter table has been
loaded, group telegrams are not forwarded)
-
Filtering broadcast telegrams (TP -> RF, RF -> TP): Forward unfiltered
-
Filtering physically addressed telegrams (TP -> RF, RF -> TP): Filter (TP-> RF forwarding
physical addresses of line 15.15)
-
Repetitions in case of TP transmission errors: yes
-
Telegram confirmation on TP line: only if transmitted
Reset delivery state (master reset)
The device can be reset to delivery state at any time, even without using the ETS.
i A reset to delivery state is useful when, for example, the device was mistakenly
commissioned with the physical address x.y.1...255, so the repeater is active. In pure
repeater operation, the device can no longer be programmed via the TP side. In this case,
a reset to delivery state is helpful in allowing the TP to be reprogrammed.
o
Disconnect the device connection terminals or switch off the power supply.
The device does not function.
o
Press and hold down the programming button.
o
Reconnect the device connection terminals or switch the power supply back on.
The device restarts. The status LED lights red briefly and then yellow. Then the status LED
flashes red slowly.
o
Release the programming button as soon as the status LED starts flashing red slowly.
Safe-state mode is active.
o
Press the programming button again and hold it down for 20 s.
The status LED goes out. The device resets to delivery state.
o
Release the programming button.
The status LED lights red-> yellow briefly. The device is in delivery state.
Order No. 5110 00
Software "Media coupler / repeater"
Functional description
Page 27 of 57
Advertisement
Table of Contents
