Download Print this page
Kenwood CM900 Series Manual
Hide thumbs Also See for CM900 Series:

Advertisement

Quick Links

safety
Only use the appliance for its
intended domestic use. Kenwood
Watch out for steam and
will not accept any liability if the
never lift the filter holder lid
appliance is subject to improper
during the brewing cycle.
use, or failure to comply with these
Never touch the hotplate.
instructions.
Always lift the filter holder lid using
before plugging in
the opening tab
.
Make sure your electricity supply is
Never touch hot surfaces.
the same as the one shown on the
Keep children away from the
underside of your machine.
machine. And never let the cord
Important (UK) only
hang down where a child could
The wires in the cord are coloured
grab it.
Wind excess cord into the cord
as follows:
storage device
.
Green and Yellow = Earth
Blue = Neutral
Never use a damaged machine.
Get it checked or repaired: see
Brown = Live.
'service and customer care'.
The appliance must be protected
Never put the machine in water or
by a 13A approved (BS1362) fuse.
let the cord or plug get wet - you
WARNING: THIS APPLIANCE
could get an electric shock.
MUST BE EARTHED.
Switch off and unplug:
Note:
● ●
before filling with water
For non-rewireable plugs the fuse
● ●
before cleaning
cover MUST be refitted when
● ●
after use.
replacing the fuse. If the fuse
Never leave the machine on
cover is lost then the plug must
unattended.
not be used until a replacement
Don't let the cord touch hot parts.
can be obtained. The correct fuse
Always make sure there is water in
cover is identified by colour and a
the tank before switching on.
replacement may be obtained
This coffee maker is only suitable
from your Kenwood Authorised
for use with the type of carafe
Repairer (see Service).
supplied.
If a non-rewireable plug is cut off it
Do not leave the machine
must be DESTROYED
switched on with an empty carafe
IMMEDIATELY. An electric shock
on the hotplate.
hazard may arise if an unwanted
Never put the carafe in the
non-rewireable plug is
microwave.
inadvertently inserted into a 13A
This appliance is not intended for
socket outlet.
use by persons (including children)
This appliance complies with
with reduced physical, sensory or
European Economic Community
mental capabilities, or lack of
Directive 89/336/EEC.
experience and knowledge, unless
they have been given supervision
before using for the first
or instruction concerning use of
time
the appliance by a person
1 Remove all packaging.
responsible for their safety.
2 Wash the parts: see 'care and
Children should be supervised to
cleaning'.
ensure that they do not play with
3 Wind excess cord into the cord
the appliance.
storage device
4 Run two lots of water through the
machine (without coffee) to clean it
out. Fill the tank to the top cup
mark when you do this. See 'to
make coffee'.
key
permanent filter
filter holder lifting tab
filter holder
anti-drip valve
coffee measuring spoon
hotplate
glass carafe and lid
on/off switch with power light
de-scale warning light
cord storage device
water tank
water tank lid
filter holder lid opening tab
de-scale reset button
to make coffee
1 Lift the tank lid and fill with the
required amount of water. The
water level must be between the
top and bottom cup marks. Do not
fill above the MAX level.
Use cold water. We recommend
using filtered water from a
Kenwood Water Filter as it
reduces limescale and prolongs
the life of your coffee maker.
Never use warm or fizzy water.
2 Ensure the filter holder is
positioned correctly.
3 Fit either the permanent filter
supplied or a paper filter into the
filter holder. Add the coffee, use
the spoon provided (approximately
1 level spoon per cup or to taste).
4 Close the lid and put the carafe on
the hotplate.
NOTE: The lid must be fitted
to the carafe in order to
operate the anti-drip valve.
5 Plug in and switch on – the neon
light will come on.
6 Don't remove the carafe until
.
brewing has finished.
The separate element for the
hotplate ensure that the coffee is
maintained at the correct
temperature after brewing.
The hotplate will keep your coffee
hot, but the sooner you drink it,
the better it will taste.
Your coffee maker will keep the
coffee warm and then
automatically switch off after 2
hours.
If you haven't used the machine
for a while, run one lot of water
through it (without coffee) to clean
it out. Fill the water tank to the top
cup mark when you do this.
care & cleaning
Always switch off, unplug and
allow to cool before cleaning.
Never put the machine in water or
let the cord or plug get wet.
Don't wash parts in the
dishwasher.
Wipe with a damp cloth, then dry.
Don't use abrasives - they'll
scratch the plastic and metal
surfaces.
removable parts
Wash in hot soapy water, then dry.
descaling
After 90 brewing cycles the de-
scale warning light will come on
and flash to indicate that the coffee
maker requires descaling (see 'to
descale')

Advertisement

loading

Summary of Contents for Kenwood CM900 Series

  • Page 1 ● This coffee maker is only suitable ● from your Kenwood Authorised Kenwood Water Filter as it Wash in hot soapy water, then dry. for use with the type of carafe Repairer (see Service). reduces limescale and prolongs descaling supplied.
  • Page 2 - it’s on the underside of the appliance. spares & attachments call 0870 2413653 ● other countries Contact the shop where you bought your appliance. CM900 series Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK www.kenwoodworld.com 56643/2...