Handling Precautions; Safety Precautions; Power Safety - Sun Microsystems StorEdge T3 Site Preparation Manual

2.1

Handling Precautions

A fully configured rackmounted array system can weigh in excess of 1400 pounds
(627 kg). Any floor that this system will cross has to be able to withstand this load.
The rackmounted system is equipped with wheels for ease in installation, and
moveability of the system prior to installation. Use enough personnel when moving
the rack, especially on sloping loading docks and ramps to gain access to a raised
computer room floor. Move the rack slowly and deliberately, and make sure the floor
is free of foreign objects and cables that the rack could roll over.
Sun Microsystems suggests that all personnel moving the rack wear protective
footwear.
Install the rack on a level surface. At each corner, on the base of the rack, are
adjustable non-skid pads. These must be extended when the rack is installed to stop
the rack from rolling around. These pads are not to be used to level the rack.
The array weighs 67 pounds (30 kg). Use two people to lift the array to avoid injury.
Choose a table or flat surface that can adequately support the arrays.
2.2

Safety Precautions

For your protection, observe the following safety precautions when setting up your
equipment:
I
I
I
2.2.1

Power Safety

I
2-2 Sun StorEdge T3 and T3+ Array Site Preparation Guide • August 2001
Follow all cautions and instructions marked on the equipment.
Ensure that the voltage and frequency of your power source match the voltage
and frequency inscribed on the equipment's electrical rating label.
Never push objects of any kind through openings in the equipment. Dangerous
voltages may be present. Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage to your equipment.
Sun products are designed to work with single phase power systems having a
grounded neutral conductor. To reduce the risk of electric shock, do not plug
Sun products into any other type of power system. Contact your facilities
manager or a qualified electrician if you are not sure what type of power is
supplied to your building.