Advertisement
Option CR3 or CRP Installation Kit
Introduction
This kit contains all of the instructions required to install Option CR3 or CRP on a Keysight MXA or
EXA signal analyzer that already has the necessary hardware installed. If the necessary hardware is
not already installed, a different upgrade kit should be used.
To install this kit, the analyzer must already have both of the following:
— A rear panel AUX IF OUT port
— A compatible Front End Controller assembly installed.
Some analyzers will have an AUX if OUT port, but will not have a compatible Front End Controller
assembly.
To verify if a compatible Front End Controller assembly is installed, press System, Show,
Hard ware. Refer to the row for the Front End Controller and note the Hw Id entry.
If the Front End Controller's Hw Id is 41 or 75, you may proceed with the installation of this kit.
If the Front End Controller's Hw Id is not either 41 or 75, do not install this kit. Instead, install the
N9010AK-HL3 kit or N9020AK-HL3, as appropriate.
4
1. At the time of manufacture the hardware related to this option was fully
adjusted and the option performance was verified to be within its warranted
specifications. Within one year of the initial calibration date of the instrument
this option is fully calibrated with no further adjustment or verification testing.
To determine the initial calibration date, locate the original calibration
certificate that was shipped with the instrument at the time of purchase. The
Date of Calibration is printed on the original calibration certificate.
To ensure that this newly installed option has been installed properly, the
procedure that follows includes a functional check.
2. The latest revision of the X-Series Signal Analyzers software may be
downloaded from
http://www.keysight.com/find/xseries_software
If a software update is required, perform the software update BEFORE
following the procedure in this document for redeeming and installing the
option upgrade license key.
3. This option is licensed for one instrument model/serial number combination.
The license key will only install on the designated instrument.
Installation Note N9020-90185
Advertisement
