Table of Contents
Advertisement
System and Network Configuration
IP Configuration
Clicking on the IP Menu (6-2A) reveals the controls for DHCP settings plus fields for entering static IP addresses,
subnets, and gateways for both the Control and AES67 Ethernet ports as well as network activity and status. It also
contains the control and server address information required NTP.
Important!
Both the Control and AES67 connections must be connected to 1000BASE-T (Gigabit) switch ports in order
to work properly.
By default, LA-5300 is set up with DHCP enabled and will automatically receive an IP address when its Control
Ethernet port is connected to a network with a DHCP server.
To use a fixed IP address, first click the Edit button (6-2D) for the appropriate port which unlocks the settings.
(Please note the Edit button of the AES67 port is used for illustration in Figure 2 as the it is replaced by the Cancel
and Apply buttons once you click on it).
Click on the Use DHCP button (6-2B) to disable DHCP. The text of the NET Address, Net Mask, and Gateway
fields, which is grayed out when DHCP is enabled, will turn white and become editable. Once the information
is entered, click on the Apply button (6-2H) to save the information or the Cancel button (6-2G) to back out
without saving any changes. Verify that you have a good network connection by looking for a green dot and the
word Active in the status window (6-2C).
Setup is identical for both the Control and AES67 ports.
Figure 6-2 – IP configuration menu
Chapter 6 | 28
Advertisement
Table of Contents
