Table of Contents
Advertisement
Installation and Initial Setup Using the Front Panel Interface
6. Repeat the above steps to edit the Netmask and Gateway fields; note that the gateway may be set to
000.000.000.000 if no gateway is required
7. After the gateway is set, press the Left button to highlight "Gateway"
8. Press the Down button to highlight "Update"
9. Press OK to save the new IP information
10. If you suddenly notice you've entered some incorrect information and need to bail out and start over, use the
Right/Left buttons to highlight "Cancel" followed by "OK"
Pressing the Right button from the IP Configuration (Control) screen will bring you to the IP Configuration
(AES67) screen. The steps for configuring this port are identical to those above for the Control port.
Finally, pressing the Right/Left buttons will eventually return you to the Home Screen.
Locate Mode
Our sincere hope is that you like your LA-5300 so much that you'll eventually end up with dozens of them pop-
ulating your racks, but since one LA-5300 looks pretty much like another, we've come up with a way to help you
identify an individual unit.
When you enable the "Locate Mode" from the remote user interface, the unit's front panel display will repeatedly
change color until Locate Mode has been cleared by pressing any key on the front panel or by clicking again on the
"Locate Mode" button on the remote user interface. Enabling Locate Mode affects only the unit's display, and has
no effect on the audio.
Special Function Key Presses
Performing a full Factory Reset and engaging the Hardware Relay Bypass are possible from the front panel by
pushing and holding a particular combination of buttons.
Factory Reset
To reset the unit to its factory defaults, simultaneously press and hold the Left, Up, and Right buttons for ten
seconds until a red countdown timer appears in the bottom left corner of the display.
Important!
Performing a factory reset will erase all I/O routing as well as any other custom settings you may have saved.
This information cannot be reclaimed once you reset the LA-5300, even by contacting customer support
or feeling genuine remorse for your decision. We strongly recommend backing up your configuration to a
computer before performing a factory reset to avoid re-setter's remorse. You have been warned!
Chapter 3 | 7
Advertisement
Table of Contents
