Torque Settings; Notes - Whyte 146 Supplementary Service Manual

8.0: TORQUE SETTINGS

Rear Quad-Link Suspension:
Link Outer Bearing Caps
M8 AeroSpace Nuts
M6 Countersunk Cap-screws (146 Y-link)
Rear Dropout Assembly
Chain ring Bolts (E-120 Dropout)
M6 cap-screws (T-120S or 146S Dropout)
Torque explained: If no suitable Torque Wrench is available a Torque of 5 lbf.ft can be obtained by apply-
ing a force of 5lb, with a Spring Balance, to the end of a spanner, 1 Foot in length.
IMPORTANT: For all other torque settings, refer to the specific manufacturers information
bundled with this manual, or alternatively, refer to the specific manufacturers website for
further information.

9.0: NOTES

Page 30
WHYTE Service Manual
2.0 (Min) / 3.0 (Max)
17.0 (Min) / 19.0 (Max)
9.0 (Min) / 10.0 (Max)
15.0 (Min) / 25.0 (Max)
10.5 (Min) / 12.5 (Max)
Nm lbs.ft
1.5 (Min) / 2.2 (Max)
12.5 (Min) / 14.0 (Max)
6.6 (Min) / 7.4 (Max)
11.0 (Min) / 25.0 (Max)
7.7 (Min) / 9.2 (Max)
2010 Edition 1