IN2/LINK CH1 LINK CH1 LP FILTER ON/OFF STEREO / BRIDGE IN1 / BRIDGE IN1+IN2 STEREO IN3/LINK CH1 LINK CH1 IN4/LINK CH2 LINK CH2 HP FILTER ON/OFF STEREO / BRIDGE IN3 / BRIDGE IN3+IN4 STEREO 51-0181-0100 EP06-06 MPA4-150R Anglès.doc 1 of 6...
Page 34
25. Now change the ST/BRIDGE IN3/BRIDGE IN3+IN4 selector to BRIDGE IN3+IN4 position 26. OUTPUT3 and OUTPUT4 should now have opposite phase, and their output level drops down 6dB. 27. Channel 4’s Signal Present indicating LED turns off. 51-0181-0100 EP06-06 MPA4-150R Anglès.doc 2 of 6...
Page 35
35. To verify the thermal protection circuits, short the thermal probe pins +Vs and Vout, and verify that the relay releases and opens up, while the THERMAL LED indicator lights on and the cooling fan increases its speed until it reaches maximum airflow. 51-0181-0100 EP06-06 MPA4-150R Anglès.doc 3 of 6...
Page 36
Vo=27Vpp (second step). Note: In both clipping cases, however, the clipped signal should be clear and free of ringings and other oscillations. 9. Repeat the same process with the remaining channels. 51-0181-0100 EP06-06 MPA4-150R Anglès.doc 4 of 6...
Page 37
The unit’s insulation should be able to resist this voltage, without generating spurious sparks or a sparkover effect, and the tester may not detect any disfunction. CAUTION: Do not disconnect nor touch the test probes until the test has finished completely! 51-0181-0100 EP06-06 MPA4-150R Anglès.doc 5 of 6...
All mechanical parts should be visually revised, in order to detect scratches on the unit's painting; all screws should be on their place, correctly tight and unmarked. Check out the unit's general presentation. 51-0181-0100 EP06-06 MPA4-150R Anglès.doc 6 of 6...
* Channel crosstalk @ 1kHz >55dB Input Sensitivity / Impedance 0dBV/>20kΩ Anticlip 2% THD Mains Voltage See characteristics in the back of the unit. Power consumption (max. Out) 1095VA Dimensions 482.6x88x391mm Weight 12.6kg * VCA OFF 53-0084-0100 EP06-06 MPA4-150R.doc 1 of 1...