20Hz and 20KHz without inducing any distortion to the output signal. Also check that when applying an input signal up to 50kHz, the unit’s output level only decreases in 1 or 2 dB, and no visible distortion is observed. 51-0184-0100 EP08-06 MPA4-400R Anglès.doc 1 of 5...
Page 34
18Vpp (210V) Note: the signal clipping should appear without any distortion or ringing. Both evaluation points are obtained by adjusting the variac’s output voltage. - Repeat this process on all the other channels. 51-0184-0100 EP08-06 MPA4-400R Anglès.doc 2 of 5...
Page 35
- Verify that channel 4’s signal present indicating LED is lit. Turn up channel 4’s input potentiometer. Verify it’s sweep. Vo=41V . Check that the output corresponds to the used channel. - Both outputs are in phase. 51-0184-0100 EP08-06 MPA4-400R Anglès.doc 3 of 5...
Page 36
The unit’s insulation should be able to resist this voltage, without generating spurious sparks or a sparkover effect, and the tester may not detect any disfunction. CAUTION: Do not disconnect nor touch the test probes until the test has finished completely! 51-0184-0100 EP08-06 MPA4-400R Anglès.doc 4 of 5...
All mechanical parts should be visually revised, in order to detect scratches on the unit's painting; all screws should be on their place, correctly tight and unmarked. Check out the unit's general presentation. 51-0184-0100 EP08-06 MPA4-400R Anglès.doc 5 of 5...
* Channel crosstalk @ 1kHz >70dB Input Sensitivity / Impedance 0dBV/>20kΩ Anticlip 1 & 5% THD Mains Voltage See characteristics in the back of the unit. Power consumption (max. Out) 2500VA Dimensions 482.6x88x426mm Weight 20.5kg * VCA OFF 53-0086-0100 EP08-06 MPA4-400R.doc 1 of 1...
Page 40
ANTICLIP SOFT ANTICLIP HARD 4xJUMPERS OFF 4xJUMPERS ON FACTORY ADJUSTED TO "HARD" POSITION J. Colomines 060918 EP08-06 MPA4-400R ECLER drawn: date: project: product: approved: title: ANTICLIP CONFIGURATION DIAGRAM 31.0225 01.00 number: version:...